|This section describes how to split your C
and Ku signal using a 22KHz switch.
The 22KHz switch, 2 HF splitters and 5 RG-6 cables are sold as a kit. Part
- Connect the C band to terminal 0 KHz, and the Ku band to
terminal 22KHz of the A/B switch.
- Connect the output of the switch (marked RX) to the Sat Cruiser
Programming the Satcruiser
Press Installation, OK
Press TP Configuration, OK
At the satellite name, select the satellite. For the 101 Ace/Plus, press Ok,
select the satellite, then press OK again. For 201P and 301 use the volume keys to select
Move down to the LNB field and press OK
For Ku band satellites set the 22KHz setting to ON, for C band satellites leave
The receiver is now ready to select the appropriate LNB automatically.